ϟ

S. Gascon

Here are all the papers by S. Gascon that you can download and read on OA.mg.
S. Gascon’s last known institution is . Download S. Gascon PDFs here.

Claim this Profile →
DOI: 10.1007/jhep03(2011)024
2011
Cited 46 times
Search for heavy stable charged particles in pp collisions at $ \sqrt {s} = 7\;{\text{TeV}} $
The result of a search at the LHC for heavy stable charged particles produced in pp collisions at $ \sqrt {s} = 7\;{\text{TeV}} $ is described. The data sample was collected with the CMS detector and corresponds to an integrated luminosity of 3.1 pb−1. Momentum and ionization-energy-loss measurements in the inner tracker detector are used to identify tracks compatible with heavy slow-moving particles. Additionally, tracks passing muon identification requirements are also analyzed for the same signature. In each case, no candidate passes the selection, with an expected background of less than 0.1 events. A lower limit at the 95% confidence level on the mass of a stable gluino is set at 398GeV/c 2, using a conventional model of nuclear interactions that allows charged hadrons containing this particle to reach the muon detectors. A lower limit of 311 GeV/c 2 is also set for a stable gluino in a conservative scenario of complete charge suppression, where any hadron containing this particle becomes neutral before reaching the muon detectors.
DOI: 10.1016/j.physletb.2011.03.060
2011
Cited 43 times
First measurement of hadronic event shapes in pp collisions at <mml:math xmlns:mml="http://www.w3.org/1998/Math/MathML" altimg="si1.gif" overflow="scroll"><mml:msqrt><mml:mi>s</mml:mi></mml:msqrt><mml:mo>=</mml:mo><mml:mn>7</mml:mn><mml:mtext> </mml:mtext><mml:mtext>TeV</mml:mtext></mml:math>
Hadronic event shapes have been measured in proton-proton collisions at sqrt(s)=7 TeV, with a data sample collected with the CMS detector at the LHC. The sample corresponds to an integrated luminosity of 3.2 inverse picobarns. Event-shape distributions, corrected for detector response, are compared with five models of QCD multijet production.
DOI: 10.1140/epjc/s10052-011-1721-3
2011
Cited 42 times
Measurement of the $\mathrm{{t\bar{t}}}$ production cross section in pp collisions at $\sqrt{s}=7$ TeV using the kinematic properties of events with leptons and jets
A measurement of the top-antitop production cross section in proton-proton collisions at a centre-of-mass energy of 7 TeV has been performed at the LHC with the CMS detector. The analysis uses a data sample corresponding to an integrated luminosity of 36 inverse picobarns and is based on the reconstruction of the final state with one isolated, high transverse-momentum electron or muon and three or more hadronic jets. The kinematic properties of the events are used to separate the top-antitop signal from W+jets and QCD multijet background events. The measured cross section is 173 + 39 - 32 (stat. + syst.) pb, consistent with standard model expectations.
DOI: 10.1103/physrevd.93.034014
2016
Cited 32 times
Measurement of the charge asymmetry in top quark pair production inppcollisions ats=8 TeVusing a template method
The charge asymmetry in the production of top quark and antiquark pairs is measured in proton-proton collisions at a center-of-mass energy of 8 TeV. The data, corresponding to an integrated luminosity of 19.6 inverse femtobarns, were collected by the CMS experiment at the LHC. Events with a single isolated electron or muon, and four or more jets, at least one of which is likely to have originated from hadronization of a bottom quark, are selected. A template technique is used to measure the asymmetry in the distribution of differences in the top quark and antiquark absolute rapidities. The measured asymmetry is A[c,y] = [0.33 +/- 0.26 (stat) +/- 0.33 (syst)]%, which is the most precise result to date. The results are compared to calculations based on the standard model and on several beyond-the-standard-model scenarios.
DOI: 10.1088/1748-0221/5/03/p03010
2010
Cited 18 times
Radiation hardness qualification of PbWO<sub>4</sub>scintillation crystals for the CMS Electromagnetic Calorimeter
Ensuring the radiation hardness of PbWO4 crystals was one of the main priorities during the construction of the electromagnetic calorimeter of the CMS experiment at CERN. The production on an industrial scale of radiation hard crystals and their certification over a period of several years represented a difficult challenge both for CMS and for the crystal suppliers. The present article reviews the related scientific and technological problems encountered.
DOI: 10.1088/1748-0221/11/04/p04012
2016
Cited 9 times
Beam test evaluation of electromagnetic calorimeter modules made from proton-damaged PbWO4crystals
The performance of electromagnetic calorimeter modules made of proton-irradiated PbWO4 crystals has been studied in beam tests. The modules, similar to those used in the Endcaps of the CMS electromagnetic calorimeter (ECAL), were formed from 5×5 matrices of PbWO4 crystals, which had previously been exposed to 24 GeV protons up to integrated fluences between 2.1× 1013 and 1.3× 1014 cm−2. These correspond to the predicted charged-hadron fluences in the ECAL Endcaps at pseudorapidity η = 2.6 after about 500 fb−1 and 3000 fb−1 respectively, corresponding to the end of the LHC and High Luminosity LHC operation periods. The irradiated crystals have a lower light transmission for wavelengths corresponding to the scintillation light, and a correspondingly reduced light output. A comparison with four crystals irradiated in situ in CMS showed no significant rate dependence of hadron-induced damage. A degradation of the energy resolution and a non-linear response to electron showers are observed in damaged crystals. Direct measurements of the light output from the crystals show the amplitude decreasing and pulse becoming faster as the fluence increases. The latter is interpreted, through comparison with simulation, as a side-effect of the degradation in light transmission. The experimental results obtained can be used to estimate the long term performance of the CMS ECAL.
DOI: 10.1007/jhep02(2016)122
2016
Cited 4 times
Search for W′ → tb in proton-proton collisions at s = 8 $$ \sqrt{s}=8 $$ TeV
A search is performed for the production of a massive W′ boson decaying to a top and a bottom quark. The data analysed correspond to an integrated luminosity of 19.7 fb−1 collected with the CMS detector at the LHC in proton-proton collisions at $$ \sqrt{s}=8 $$ TeV. The hadronic decay products of the top quark with high Lorentz boost from the W′ boson decay are detected as a single top flavoured jet. The use of jet substructure algorithms allows the top quark jet to be distinguished from standard model QCD background. Limits on the production cross section of a right-handed W′ boson are obtained, together with constraints on the left-handed and right-handed couplings of the W′ boson to quarks. The production of a right-handed W′ boson with a mass below 2.02 TeV decaying to a hadronic final state is excluded at 95% confidence level. This mass limit increases to 2.15 TeV when both hadronic and leptonic decays are considered, and is the most stringent lower mass limit to date in the tb decay mode.
2023
Autoencoder-based Anomaly Detection System for Online Data Quality Monitoring of the CMS Electromagnetic Calorimeter
DOI: 10.5167/uzh-140765
2016
Observation of Upsilon(1S) pair production in proton-proton collisions at sqrt(s) = 8 TeV
DOI: 10.1016/j.physletb.2016.063.027
2016
Measurement of the inelastic cross section in proton-lead collisions at a centre-of-mass energy per nucleon pair of 5.02 TeV
The inelastic hadronic cross section in proton-lead collisions at a centre-of-mass energy per nucleon pair of 5.02 TeV is measured with the CMS detector at the LHC. The data sample, corresponding to an integrated luminosity of 12.6 +/- 0.4 inverse nanobarns, has been collected with an unbiased trigger for inclusive particle production. The cross section is obtained from the measured number of proton-lead collisions with hadronic activity produced in the pseudorapidity ranges 3<abs(eta)<5 and/or -5<abs(eta)<-3, corrected for photon-induced contributions, experimental acceptance, and other instrumental effects. The inelastic cross section is measured to be sigma[inel,pPb]=2061 +/- 3 (stat) +/- 34 (syst) +/- 72 (lum) mb. Various Monte Carlo generators, commonly used in heavy ion and cosmic ray physics, are found to reproduce the data within uncertainties. The value of sigma[inel,pPb] is compatible with that expected from the proton-proton cross section at 5.02 TeV scaled up within a simple Glauber approach to account for multiple scatterings in the lead nucleus, indicating that further net nuclear corrections are small.
2017
Measurement of the ttbar production cross section using events with one lepton and at least one jet in pp collisions at sqrt(s)=13 TeV
A measurement of the ttbar production cross section at sqrt(s)=13 TeV is presented using proton-proton collisions, corresponding to an integrated luminosity of 2.3 inverse femtobarns, collected with the CMS detector at the LHC. Final states with one isolated charged lepton (electron or muon) and at least one jet are selected and categorized according to the accompanying jet multiplicity. From a likelihood fit to the invariant mass distribution of the isolated lepton and a jet identified as coming from the hadronization of a bottom quark, the cross section is measured to be sigma(ttbar)= 835 +/- 3 (stat) +/- 23 (syst) +/- 23 (lum) pb, in agreement with the standard model prediction. Using the expected dependence of the cross section on the pole mass of the top quark (m[t]), the value of m[t] is found to be 172.7+2.4-2.7 GeV.